Water Damage Restoration – What Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the property could be due to an overflow, flood or any other water damage event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. The two main large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) and also the RIA (Restoration Industry Association) that recommends standards for water damage and mold restoration. The S500 damage because of water guide is the benchmark tool that is used by companies specializing in restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the foremost and the most crucial element of water damage restoration. The assessment has to be correct in order that an appropriate response can be used. In restorating the injury due to water, technicians and also the insurance firms must work together and know very well what is damaged and the way to restoring the damage. Identifying the cause of the damage, documentation of damage, and accurate estimates are mandatory for any proper water damage and mold restoration. Categorization is based on the contamination amounts of the water source. The categories are listed below
Category 1 – This really is water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This is water which has some contaminants like water from a dishwasher, washing machine or toilet with urine.
Category 3 – This is water that is certainly highly unsanitary and is capable of doing causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are a handful of examples.
Decontamination and Drying – Following the evaluation is done, the entire process of drying and decontaminating begins at the site. Based on the extent of damage, damage caused due to water can be classified into 4 types. Class 1 Damage- When loss is restricted to a small area and much less water has been absorbed by materials. This brings about slow evaporation rate. Class 2 Damage – When the damage is always to the complete room and carpet area. Class 3 Damage – When the entire area is saturated with water and sophistication 4 Damage – when there are lots of deep saturation pockets. Decontamination and drying is really a key stage in Water damage restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments need to be used. Decontamination must be done if contamination has been detected in the community. Decontamination may be done for the whole area or in specific pockets where contamination continues to be detected.
Monitoring and Completion – Monitoring the restoration procedure for damage caused because of damage is crucial to achieve the desired results. One has to be proactive during the monitoring process. Checking if the drying tools are setup properly, assessing if the personnel involved are qualified for the job and checking in the event the equipments will be in working order inwtsy all portion of the monitoring process. Necessary steps are to be taken if anything wrong is spotted during the monitoring process. The complete process of water damage restoration could be considered complete just once the humidity, temperature and the moisture content is really as per industry standards. Upon completing the water damage restoration process, the drying equipment can be removed.